Waeco CF-80 Instruction Manual download pdf (Page 16)

Operation

In “HIGH” mode, the battery monitor responds faster than at the

levels “LOW” and “MED” (see the following table).

This is how to select the battery monitor mode:

➤ Switch on the cooler.

➤ Press the “SET” button (fig. 2 4, page 3) three times.

➤ Use the “UP +” (fig. 2 6, page 3) and “DOWN -” (fig. 2 7,

page 3) buttons to select the battery monitor mode.

✓ The selected mode then appears in the display for a few sec-

onds. The display flashes several times before it returns to the

current temperature.

Note

When the cooler is supplied by the starter battery, select the battery

monitor mode “HIGH”. If the cooler is connected to a supply battery,

the battery monitor mode “LOW” will suffice.

If you wish to operate the cooler from the AC mains, set the battery

monitor to the “LOW” position.

6.5 Using the cooler

Caution – Danger of overheating!

Ensure at all times that there is sufficient ventilation so that the

heat that generated during operation can dissipate. Ensure that

the ventilation slots are not covered. Make sure that the device

is sufficiently far away from walls and other objects so that the

air can circulate.

➤ Place the cooler on a firm foundation.

Make sure that the ventilation slots are not covered and that the

heated air can dissipate.

➤ Close the cooler, see “Connecting the cooler” on page 31.

Battery monitor mode LOW MED HIGH

Switch-off voltage at 12 V

10.1V 11.4V 11.8V

Restart voltage at 12 V

11.1 V 12.2 V 12.6 V

Switch-off voltage at 24 V

21.5 V 24.1 V 24.6 V

Restart voltage at 24 V

23.0 V 25.3 V 26.2 V

_CF-80_110.book Seite 34 Montag, 19. Dezember 2011 8:30 20

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

No comments

Waeco CF-80 Instruction Manual Page 16