10
GB
Attention, danger! Never manipulate plugs or switches with wet hands
or when your feet are in contact with water! If you operate your cooling
device on board of a boat by means of shore connection to 230 V-net-
work, you must in any case insert a residual current device.
Contact a specialist for advice!
Cleaning
Your cooling device will be delivered cleaned from the factory – you nevertheless
should clean prior to initial use. Take a cloth which has been slightly moistened
with lukewarm water. Pay attention that no water drops into the seals and possibly
damages the electronics. Dry off the cooling device with a cloth after cleaning.
Clean the device periodically and as soon as it is dirty.
Attention: Never use solvents or agents with sand or acid parts for
cleaning the cooling tank.
Never use brushes, graters or hard and sharp tools.
Putting into service
Switch on the coolbox by pressing the “on“ button or pushing the slide switch to
“high” for operation at a starter battery or to “low” for the operation at a service
battery. The LED beside the switch on button is a flashing light and flashes only if
the battery power is insufficient for supply of the coolbox. If this is the case, check
your battery.
Putting out of service
If you wish to cut out the cooling device for a longer period, remove the plug
from the AC line or desconnect the cooling device cable from the battery. Clean
the cooling device and leave the lid slightly open. Thus preventing the formation
of mold.
Defrosting
Air humidity can deposit on the evaporator or in the interior of the cooling device
as frost so that the refrigerating performance is reduced. In order to remove the ice
coat never use hard or sharp tools which can cause damage to the plastics or the
evaporator.
Therefore defrost the cooling device in good time. Take out the refrigerated pro-
ducts and store them in another cooling device so that they remain refrigerated.
Switch off the box and leave the lid open. Wipe the condensed water
or – if existing – empty the drip basin.
Changing the light
In case your coolbox is equipped with an interior light, this electric light bulb may
be exchanged.
Grab the lamp at the switch pin and press this pin forwards, so that the transparent
part of the lamp separates from the housing. Now you can exchange the electric
light bulb and put the lamp back into the housing.
(20 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals