Waeco CF-25 Instruction Manual download pdf (Page 38)

Operation

➤ Plug the 100–240 V connection cable (Fig. 1 3, page 3) into

the AC voltage socket and connect it to the 100–240 V AC

voltage mains (only CF-35, CF-40, CF-50, CF-60).

CF-18, CF-25

To operate the coolers CF-18 and CF-25 from the 220–240 V AC

mains, use the rectifier WAECO CoolPower EPS100 (accessory).

6.4 Using the battery monitor

The device is equipped with a multi-level battery monitor that

protects your vehicle battery against excessive discharging when

the device is connected to the on-board 12/24 V supply.

If the cooler is operated when the vehicle ignition is switched off,

the cooler switches off automatically as soon as the supply voltage

falls below a set level. The cooler will switch back on once the

battery has been recharged to the restart voltage level.

Caution – Danger of damage!

When switched off by the battery monitor, the battery will no longer

be fully charged. Avoid starting repeatedly or operating current

consumers without longer charging phases. Ensure that the battery

is recharged.

In “HIGH” mode, the battery monitor responds faster than at the

levels “LOW” and “MED” (see the following table).

CF-18

CF-25, CF-35, CF-40,

CF-50, CF-60

Battery monitor mode LOW HIGH LOW MED HIGH

Switch-off voltage at 12 V

10.4 V 11.5 V 10.1 V 11.4 V 11.8 V

Restartvoltage at 12 V

11.5 V 12.5 V 11.1 V 12.2 V 12.6 V

Switch-off voltage at 24 V

22.1 V 24.0 V 21.5 V 24.1 V 24.6 V

Restart voltage at 24 V

23.6 V 25.4 V 23.0 V 25.3 V 26.2 V

_CF-18_60.book Seite 38 Donnerstag, 26. Juli 2007 3:18 15

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 207 208

No comments

Waeco CF-25 Instruction Manual Page 38